If you have any trouble following the below setup process, please contact the Snackpass customer support team at +1 866 868 2146 (call) or message us using the Partner App!
Note: The model B3 can be used as a kiosk, register or customer pickup screen
Installation
Remove the Model B3 from the box
If using the B3 as a kiosk or register:
Place the card reader on the card reader mount and make sure it snaps into place
Plug the USB-C side of the cable into the card reader and the USB-A side into the kiosk/register
Note: please make sure that the cable is securely plugged into the card reader and the kiosk/register
Place the B3 where you would like it to be in your store
Once the B3 is in the preferred location, take the power cable and plug it into the monitor and the other end into an outlet
Note: Use an extension cord or power strip as neededThe B3 will power on
Wait up to 1 minute for the device to power on - if it does not power on, press the power button on the back of the monitor
if it still does not power on, check the connections at the monitor and at the outlet (or power strip/extension cord) then try the power button again
Connect the device to the internet
Note: The preferred connection method is an ethernet connection but WiFi will work as wellTo register the device to your store, follow this guide
Tidy up the cabling so that it will not get caught or snagged and is as hidden/neat as possible
Your setup should now be complete! Run a test order and see what that kiosk/register/CPS can do!
If you have any trouble following this installation guide, please contact the Snackpass customer support team at +1 866 868 2146 (call) or message us using the Partner App!