What’s in the Box:
1 x 15" or 21" Screen (one of these)
1 x Ethernet Cable
1 x Clamp Mount
4 x M4 Screws
Step-by-Step Installation:
1. Pick a Spot:
Choose a Stable Surface Close to an Outlet: Find a stable surface near an electrical outlet. This will make it easy to plug in your screen later.
Note: Make sure the spot you choose allows the clamp to hold tight without moving around.
2. Attach the screen
Attach the clamp mount to the screen: Position the clamp mount against the rear side of the screen (either the 15-inch or 21-inch model), aligning the mounting holes. Securely fasten the mount to the screen using 4 x M4 screws, ensuring that each screw is tightened evenly. Be cautious not to overtighten to avoid damage to the screen. Confirm stability and proper alignment once all screws are in place.
3. Set Up the Clamp:
Choose a Stable Surface Close to an Outlet: Place the clamp mount on the chosen surface. Tighten the handle underneath the clamp by twisting it until the clamp holds firmly and doesn't wiggle.
Note: It’s essential to ensure the clamp mount is tightly fastened and stable. This step is crucial for the overall stability and functionality of your KDS. A secure setup prevents any movement, protecting your equipment from potential damage.
4. Connect to internet:
Connecting it to a network: If connecting over ethernet, plug one end of the Ethernet cable into the LAN port on the bottom side of the screen. If connecting to WiFi, follow these steps.
