Need help? Contact Snackpass Support at +1 866 868 2146 or message us in the Partner App
The Clamp-Mounted Kitchen Display System (KDS) is built for stable, space-efficient installation on a variety of surfaces. It’s ideal for busy kitchen environments in quick service restaurants (QSRs) and can also be mounted in compact spaces, such as shelves or counters, to keep workflows organized and efficient. Its secure clamp design makes it a flexible choice for both permanent and semi-mobile setups.
Device Overview
Device Type: KDS
Screen Size: 15.6" — 12in x 14.5in x 8.8in
Power/Charging: AC power adapter
Mount Type: Clamp mount (compatible with shelves, countertops, and tables)
Video Instructions
Step-by-step Instructions
Package Contents
1 x 15.6" Display | Clamp Mount | Power Cable | 10 ft Ethernet Cable
Installation
Step 1 : Attach VESA to display
Attach the VESA portion of the clamp to the display using the 4 included thumb screws. Tighten all 4 screws.
Step 2: Prepare the Clamp Mount
A. Position the clamp on the installation surface (shelf, table, or counter). Tighten the clamp until secure, ensuring it’s stable and does not wobble.
Step 3: Attach the KDS to the clamp mount
A. Align the two hooks on the display’s VESA mount with the metal prongs on the clamp mount’s VESA attachment. Once aligned, slide the display down into place.
B. Insert the set screw into the hole at the top of the clamp mount pole, making sure the holes are properly aligned. Avoid over-tightening to prevent stripping the screw.
Step 4: Tilt the Screen to the Desired Angle
A. Loosen the set screw installed in Step 3 until the display can be adjusted. Tilt the screen to your preferred angle, then tighten the screw.
Step 5: Power & Network Setup
A. Connect the kiosk’s power cable to the power port.
B. Connect the ethernet cable to the ethernet port.
Note: For the most reliable and consistent performance, connect the kiosk to Ethernet. The ethernet port can be found on the opposite end of where the power cable is plugged in. Use the diagram to locate the ports.
Step 6: Final Hardware Checklist
Mount Stability – Clamp mount is tight and stable (no movement).
Set Screw – Ensure the set screw is snug but not overtightened.
Power Connection – Power cable connected to brick and plugged into a grounded outlet.
Network Connection – Ethernet with green lights active on the router, or Wi-Fi setup completed.
Next Steps
Installation Complete
You're all set!
The hardware setup for your clamp mounted kiosk is now finished.
If you have any trouble following the installation process, please contact the Snackpass customer support team at +1 866 868 2146 (call) or message us using the Partner App!