Unbox the kiosk/register and place onto the desired countertop location

Remove the cable cover from the base

Route the power cord through the hole inside the base and plug it into the power port

Plug the other end of the power cable into a 120V wall outlet

Note: use a power strip or extension cord as needed

Remove the card reader and the card reader mount from the box. Slide the card reader onto the mount, you should hear a slight click when it is in place

Route the card reader power cable through the hole, plug it into one of the USB-A ports and then plug the USB-C end into the card reader

Note: The ports are labeled on the device and also shown in the diagram below

Hold down the power button (found on the back of the register-side of the monitor) until the register's screen powers on (power button will light up blue and a graphic will appear on the screen)

Internet connection:

Note: The preferred connection method is an ethernet connection but WiFi will work as well

Once connected to the internet, the device will open the Snackpass welcome app

To register the device to your store, follow this guide

To connect the card reader to the kiosk/register, follow this guide

Note: The D4 & B4 only ship with the M2 card reader, M2 card readers MUST be connected over bluetooth, the USB connection will only keep the device powered and charged

To connect a cash drawer, follow this guide

Hook the cables behind the cable hooks inside the base

Put the cable cover back onto the kiosk/register and situate the card reader in the desired location

Note: Make sure the cables are tucked behind the cable clip and centered where the cable cover hole is located or the cover will not close properly

Tidy up the cabling so that it will not get caught or snagged and is as hidden/neat as possible